for banner/welder/pvc/tent use hot air welding machine - Lecai-50

1--First of all,lighten up the spraying cloth, target the sew.(2-5cm),and fix the cloth on the ground with glue or tape.

2--Insert the power(picture),turn the handle to the left,till the spout is straight-line with the wheel.The turn the black button to the right ,adjust the speed, usually put it on 2.After adjust

3--the speed,turn the handle to the right till the spout leave the ground.Then it stops.

4--Adjust the temperature.Turn on the temperature button(turn the golden button to the right,it make the voice “Ka”.Then press the temperature up and down button,adjust the temperature according to the thickness and durable of the cloth,usually put it between300°Cand350°C.Or you can put some materials in the spout,if the materials melt immediately and shouldn’t scorch.It is the proper temperature.

5--After adjust the temperature and speed,put the edge of the right-wheel in a level with the edge of sew.When the actual temperature reach to your set temperature,turn the handle to the left till the spout insert into the sew totally.The machine beginstowalk.Splicing begins..

6--During splicing,if the spout melt the spraying cloth. Fist you should turn black button to the right a little,or you can turn down the temperature.(choose one from the two ways) in that way,it won’t melt the cloth.But you shouldn’t turn the button in very urgent speed,or it will make the machine can’t weld or damage the cloth.

7--Before using,please find a proper temperature and speed.If slow,it will damage the cloth;if fast,it may stick not so fasten,so it is important to adjust the temperature and speed.

8--On the completion of splicing ,turn the handle to the right ,till the spout leave the spraying cloth totally.At this time,you can turn off the temperature button.But you couldn’t turn off the power cord and the power button, in case the heat damage the heat gun,and make the machine couldn’t work.You must wait till its actural temperature reach to the lowest.

9--Don’t use the machine in wet weather.The working place must be dry and flat.Pay attention to the fire, the machine should have technical person to operate. The working voltage is 110V-240V(two types) To open the machine,you should be responsible for the result yourself.

10--The warranty period is six months,heating elements are not in the warranty scope due to it being a repid-wear article,and we are only responsible for the supply of fitting,but the cost is subject to the client.

11--Fitting equipped along with the machine include a source line of 10m,a piece of alternate heating element,a instrution book and a CD.

12--we won’t notify if the products have some change.Please tell the agents in local area, the introduction is only for reference,don’t have legal effect.The factory has the final interpretation.

13--All the products of this factory have applied the national patents.And the trademark has been registered,no copy allowed.